The charcoal machine is a machine that crushes the wood chips into particles within 10mm after being crushed by a sawdust crusher, and then puts them into a carbonization furnace for carbonization after being dried and formed by a dryer. The charcoal produced by this charcoal machine has high density, small volume, good combustibility, and can replace firewood and coal. This product is especially suitable for heating kangs in autumn and winter in northern regions, heating greenhouses, or as ordinary living fuel. The complete set of charcoal machine equipment includes a charcoal rod making machine, a carbonization furnace, a dryer and other equipment. Let me tell you how to make better charcoal rods.
The machine-made charcoal produced by the new charcoal machine is an effective use of biomass new energy. In the process of using the machine-made charcoal machine to produce machine-made charcoal, high temperature is indispensable. When using a rod making machine to form, it is necessary to extrude and form under high temperature and high pressure. There is a heating ring outside the rod making machine. It is heated to 260-350 degrees Celsius through the heating ring to ensure that the carbon rods produced reach the required density. When using the rod making machine to form, there is a place to pay attention to. That is, the rod making machine should be preheated before discharging the material during forming, and the production and processing of the rods should be carried out. The quality of the carbon rod depends not only on the equipment and process, but also on the amount of water contained in the raw materials. Generally, the moisture content of the raw materials is required to be less than 12%, but also greater than 6%, so as to greatly avoid the firewood rods made from excessive moisture content.
If the new charcoal machine wants to complete the production of charcoal, a very important step is the selection and use of the carbonization furnace. The carbonization furnace is the key factor in determining the quality of carbonization, so the charcoal machine carbonization furnace must be further understood before using it.
1. The carbonization furnace is composed of steel plates and high-temperature refractory materials; generally speaking, its volume is 4-6 cubic meters and the output is 1-2 tons.
2. One ton of logs can produce about half a ton of charcoal; there is a fan above the carbonization furnace to directly remove the smoke.
3. The carbonization time of the whole furnace of logs is 4 days; a small amount of fuel straw, branches, etc. is required.
4. Carbon monoxide and carbon dioxide emissions are very small; corn stalks, peanut shells, etc. require about 10 hours of carbonization time.
The specific requirements of the new charcoal machine carbonization furnace are to understand its loading capacity and carbonization time, ignition holes, and water treatment devices. The loading capacity of a 6 cubic carbonization furnace is 3 tons, and the finished charcoal is 1.5 tons. The cycle of the charcoal machine carbonization furnace is relatively long, and it adopts advanced hot air flow carbonization technology to greatly improve the carbonization rate.
